MINI Lighting & Control System Components

System

The MINI, Lighting & Control System is a simple, pre-programmed lighting control designed for small installations, or as an instructional tool for academic institutions wishing to demonstrate low-voltage lighting and control. It is well suited for RVs, basements, garages, man caves, she sheds, pool houses, and small barns. 

The MINI System supports:

  • Four LED channels (up to seven 6W fixtures each)
  • One switch chain (6 buttons)
  • One motion sensor input.

Unlike the Single and Multi Board systems, the MINI does not support Internet connectivity and remote control.

Switching

The first four switch buttons are preprogrammed to control channels 1, 2, 3, and 4, respectively. Button five controls all four channels. Button six is used to deactivate or activate the motion sensor.

Buttons 1-5 are configured as toggle/dimmers. If pressed and release momentarily, lights are toggled on/off. If pressed and held for more than one second, lights ramp up or down to the desired level. Simply release the switch to set the light level.

Button Functions

  • Buttons 1-4 function as both a toggle and a dimmer for drivers 1-4, respectively.
  • Button 5 functions as both a toggle and a dimmer to control all drivers.
  • Button 6 toggles motion on and off. 

Any number of separate switch locations can be used to trigger any of these 6 functions.

Motion Activation

All four channels can also be motion activated. When motion is detected, lights are turned on and back off 15 minutes after motion ceases.

Depending on your application, you may choose between four pre-programmed versions of the MINI System configuration.

Motion – 4 versions

  • V1: MINI System: Motion activates channel 1 only
  • V2: MINI System: Motion activates channel 1 & 2
  • V3: MINI System: Motion activates channel 1,2 & 3
  • V4: MINI System: Motion activates channel 1,2,3 & 4
Paired with PMMI Lighting’s six button switch, motion sensor and light fixtures, the MINI Board System is an economical answer for applications where pre-programmed functions are adequate.

In applications where more flexibility is needed, consider stepping up to the Single or Multi-Board systems.


MINI Board System available:

MINI, Lighting & Control System – Plug & Play (specify V1, 2, 3, or 4)

  • Part# 9730
  • The MINI Board, Power Supplies & Power Chord assembled and connected.
  • Mounted in a 14 inch Enclosure, fully functional when plugged in.
  • Six Button Switch
  • Motion Sensor
  • Fixture termination plugs – 4 quantity
  • No-Ox-ID
  • Not included: Fixtures, Cat5/6 cable, tools or additional switches or motion sensors if desired

MINI Lighting & Control System – DIY Kit (specify V1, 2, 3, or 4)

  • Part# 9720
  • MINI Board
  • Six Button Switch
  • Motion Sensor
  • 12V Power Supply for system electronics
  • 48V Power Supply for light fixtures
  • Power Chord
  • Hardware packet (fixture termination plugs, mounting brackets, spacers, screws and wire for mounting)
  • No-Ox-ID
  • Not included: Fixtures, Cat5/6 cable, tools or additional switches or motion sensors if desired

MINI Lighting & Control Board, Switch & Motion – Basic Pkg (specify V1, 2, 3, or 4)

  • Part# 9740
  • MINI Board
  • Six Button Switch
  • Motion Sensor
  • Not included: Power Supplies, Power Chords, No-Ox-ID, Hardware, Fixtures, Fixture termination plugs, Cat5/6 cable, tools or additional switches or motion sensors if desired

MINI Lighting & Control System Catalogue & Installation Manual 

MINI Catalogue & Installation Manual

For more information, or to place an order: